Arduino+NRF24L01

[dan21]

Zdravim,
Mam zostavu prijmac Nano+NRF24L01 a vysielac Nano+NRF24L01
Skusil som rozne priklady (RF24) ale stale mi nejde komunikacia.
Vedel by niekto poradit ? Nejaky jednoduchy funkcny priklad ?
Toto je printDetails z obidvich zariadeni. Mozno mam nieco zle nastavene.
Diky
RF24/examples/starping/
ROLE: Pong back
ADDRESS: 1
SPI Speedz = 10 Mhz
STATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0x3a3a3a3aa5 0xf0f0f0f0d2
RX_ADDR_P2-5 = 0xc3 0xb4 0xa5 0x96
TX_ADDR = 0x3a3a3a3aa5
RX_PW_P0-6 = 0x20 0x20 0x20 0x20 0x20 0x20
EN_AA = 0x3f
EN_RXADDR = 0x3e
RF_CH = 0x4c
RF_SETUP = 0x03
CONFIG = 0x0f
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1 MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_LOW
ARC = 15

RF24/examples/starping/
ROLE: Ping out
ADDRESS: 5
SPI Speedz = 10 Mhz
STATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0xf0f0f0f0a5 0x3a3a3a3aa5
RX_ADDR_P2-5 = 0xc3 0xc4 0xc5 0xc6
TX_ADDR = 0xf0f0f0f0a5
RX_PW_P0-6 = 0x20 0x20 0x20 0x20 0x20 0x20
EN_AA = 0x3f
EN_RXADDR = 0x02
RF_CH = 0x4c
RF_SETUP = 0x03
CONFIG = 0x0f
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1 MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_LOW
ARC = 15

[dan21]

Uz som to vyriesil. Moze sa zmazat.
Pouzil som upraveny priklad odtialto
https://github.com/SensorsIot/NRF24L01- ... cation.ino